How to configure PB Printer to work through USB Cable ?

HOLD BOTH STATION1 and STATION2 BUTTONS IN THE PRINTER

Switch on the printer

Leave the Buttons

Insert the paper into the printer

Automatically Printer will take the paper inside and a message will be printed as follows

STATION 1-CONFIRM STATION 2=SKIP PRESS LOCAL TO CONTINUE

Press LOCAL and then STATION 1

The Default Configuration will be printed as follows

MENU : CONFIG Press STATION 1

DRAFT SPEED: NORMAL Press STATION 1

LQ TYPE: NLQ1 Press STATION 1

PAPER WIDTH: FIRST LINE Press STATION 1

BUZZER: Y Press STATION 1

INTERFACE By default SERIAL or COM1 will be there Press STATION2

Till USB is printed and then Press STATION 1

USB EMULATION By default OLIVETTI will be there Press STATION2

Till IBM is printed and then Press STATION 1

PLUG&PLAY: N Press STATION 1

PAP.EDGE DECTEC.: N Press STATION 1

SPECIAL FORMS: N Press STATION 1

PRINT MODE STANDARD Press STATION 1

BIM MODE: MONO Press STATION 1

PNS SELECTIONS: N Press STATION 1

SAVE PARAMETERS Y Press STATION 1

MENU : CONFIG

Leave the paper in the printer and switch off the printer (Press power button in the PB printer)

SWITCH ON THE PRINTER

Automatically the paper will be ejected

THE SAME METHOD MAY BE USED TO CONFIGURE SERIAL OR COM1 PORT

Thanks to :

P N Satish
Postmaster Grade – I
Byndoor Post Office,
Udupi Division, Karnataka - 576214

How to configure PB Printer to work through USB Cable ?